JNP10K-PWR-AC Power Supply LEDs | 70
JNP10K-PWR-AC2 Power Supply LEDs | 72
JNP10K-PWR-DC Power Supply LEDs | 73
JNP10K-PWR-DC2 Power Supply LEDs | 75
The MX10000 modular routers support AC, DC, high-voltage alternating current (HVAC) and high-voltage
direct current (HVDC) by offering the following power supplies:
•
JNP10K-PWR-AC
•
JNP10K-PWR-AC2
•
JNP10K-PWR-DC
•
JNP10K-PWR-DC2
All of the power supplies are hot-insertable and hot-removable, field-replaceable units (FRUs). You can
install up to six power supplies in an MX10008 router in the slots labeled PEM 0 through PEM 5 (top to
bottom) located in the rear of the chassis. In the MX10016, you can install up to 10 power supplies in the
slots labeled PEM 0 through PEM 9 (top to bottom) located in the rear of the chassis. You can install the
power supplies in any slot.
The JNP10K-PWR-AC2 and JNP10K-PWR-DC2 power supplies require the enhanced power bus. To
determine whether your system has the standard power bus or the enhanced power bus, see “MX10008
Status Panel LEDs” on page 39. Table 13 on page 60 provides the specifications for these different power
supplies.
Table 13: Power Supply Overview
JNP10K-PWR-DC2JNP10K-PWR-DCJNP10K-PWR-AC2JNP10K-PWR-AC
5500 W when set for
high power (80-A) or
4400 W when set for
low power (60-A)
2500 W5000 W or 5500 W
when set for high power
(30-A); 3000 W when
set for low power (20-A)
2700 WMaximum
output power
4 (INPUT 1, INPUT 2)2 (INP1, INP2)2 (INP1, INP2)2 (INP1, INP2)Inputs
Standard or enhanced*StandardStandard or enhanced*StandardCompatible
power bus
60
To Next Page
Loading...
