Juniper MX10008 - Page 6

Initial Installation and Configuration
3
MX10008 Installation Overview | 131
Unpacking the MX10008 Router and Components | 132
Unpacking the MX10008 | 132
Unpacking Line Cards, RCBs, and Switch Fabric Boards | 135
Comparing the MX10008 Order to the Pack | 136
Installing the Mounting Hardware | 140
Installing the MX10008 into a Rack | 143
Mounting an MX10008 in a 4-Post Rack Using a Mechanical Lift | 143
Manually Mounting an MX10008 in a 4-Post Rack | 147
Installing the Front Panel on an MX10008 | 151
Connecting the MX10000 to Power | 158
Connecting an MX10000 to Earth Ground | 160
Connecting AC Power to an MX10000 | 163
Connecting DC Power to an MX10000 | 164
Connecting the MX10008 to External Devices | 164
Connecting an MX10008 to a Network for Out-of-Band Management | 165
Connecting an MX10008 Router to a Management Console | 166
Configuring an MX10008 Router | 167
Maintaining Components
4
Field-Replaceable Units in an MX10008 | 173
Removing and Installing Routing and Control Boards | 174
Removing a Routing and Control Board | 175
Installing a Routing and Control Board | 176
Removing and Installing MX10008 Cooling System Components | 178
Removing an MX10008 Fan Tray | 179
Installing an MX10008 Fan Tray | 183
Removing an MX10008 Fan Tray Controller | 186
Installing an MX10008 Fan Tray Controller | 188
vi