Removing and Installing MX10000 Power System Components | 191
How to Remove a JNP10K-PWR-AC Power Supply | 191
How to Install a JNP10K-PWR-AC Power Supply | 196
How to Remove a JNP10K-PWR-AC2 Power Supply | 204
How to Install a JNP10K-PWR-AC2 Power Supply | 208
How to Remove a JNP10K-PWR-DC Power Supply | 215
How to Install a JNP10K-PWR-DC Power Supply | 220
How to Remove a JNP10K-PWR-DC2 Power Supply | 230
How to Install a JNP10K-PWR-DC2 Power Supply | 234
Removing and Installing MX10008 Switch Fabric Boards | 244
Handling and Storing MX10008 Line Cards, RCBs, and SFBs | 244
Holding Line Cards and Routing and Control Boards | 244
Holding Switch Fabric Boards | 246
Storing Line Cards, RCBs, and SFBs | 247
Removing an MX10008 Switch Fabric Board | 248
Installing an MX10008 Switch Fabric Board | 251
Replacing an MPC | 256
Removing an MPC | 256
Installing an MPC | 259
Install the Cable Management System | 261
Removing and Installing Transceivers and Fiber-Optic Cables | 264
Remove a Transceiver | 265
Install a Transceiver | 267
Disconnect a Fiber-Optic Cable from a Router | 269
Connect a Fiber-Optic Cable to a Router | 270
Maintain the Fiber-Optic Cables in a Router | 271
Removing the MX10008 Router | 272
Powering Off an MX10008 Router | 272
Removing an MX10008 Router From a Four-Post Rack Using a Mechanical Lift | 275
Manually Removing an MX10008 Router from a 4-Post Rack | 276
vii
To Next Page
Loading...
