Figure 35: LEDs on a JNP10K-PWR-DC Power Supply
3—1— PWR OKINP1–Source input 0
4—2— FAULTINP2–Source input 1
Table 19 on page 74 describes the LEDs in an MX10008.
Table 19: LEDs on a DC Power Supply in an MX10008
DescriptionStateColorLED
Indicates that the DC power input voltage is not
within normal operating range.
BlinkingYellowINP1 or INP2
DC power is within operating range (-40 VDC to -72
VDC).
SolidGreen
The power supply is switched off.OffUnlit
DC power output is within normal operating range.SolidGreenPWR OK
DC power output is out of the normal operating
range.
BlinkingYellow
Power supply has failed and must be replaced.SolidRedFAULT
The power supply is functioning normally. Or, only
one input is powered and the enable router for the
input that is not powered is set to ON. See
“Connecting DC Power to an MX10000” on page 164
for more information on the enable switches.
OffUnlit
74
To Next Page
Loading...
