CAUTION: If you face a problem running a Juniper Networks device that uses a third-party
optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help you
diagnose the source of the problem. Your JTAC engineer might recommend that you
check the third-party optic or cable and potentially replace it with an equivalent Juniper
Networks optic or cable that is qualified for the device.
SEE ALSO
Supported Transceivers
PTX10000 Cable Specifications for Console and Management Connections
Table 69 on page 185 lists the specifications for the cables that connect the PTX10000 line of routers to
a management device.
NOTE: The PTX10000 models can be configured with SFP management ports that support
1000BASE-SX transceivers.
Table 69: Cable Specifications for Console and Management Connections for the PTX10000 Line of Routers
Device
Receptacle
Maximum
LengthCable SuppliedCable Specification
Port on
PTX10000
Router
RJ-457 feet
(2.13 meters)
One 7-foot (2.13-meter) long
RJ-45 patch cable and RJ-45
to DB-9 adapter
RS-232 (EIA-232) serial
cable
Console port
RJ-45328 feet
(100 meters)
One 7-foot (2.13-meter) long
RJ-45 patch cable
Category 5 cable or
equivalent suitable for
1000BASE-T operation
Management port
SEE ALSO
185
To Next Page
Loading...
