Figure 110: ESD Point on PTX10016 Chassis Front
3. Simultaneously rotate the RCB handles counterclockwise to unseat the RCB.
4. Grasp the handles and slide the RCB about halfway out of the chassis (see Figure 111 on page 251).
Figure 111: Removing a Routing and Control Board
5. Grasp each side of the RCB and slide it completely out of the chassis.
6. Place the RCB on the antistatic mat.
7. If you are not replacing the RCB now, install a cover in the empty slot.
SEE ALSO
Handling and Storing PTX10000 Line Cards, Routing and Control Boards, and SIBs | 321
251
To Next Page
Loading...
