Juniper PTX10008 - Page 280

5. Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver, number 1. See
Figure 147 on page 284 and Figure 148 on page 284.
Figure 147: Removing a JNP10K-PWR-AC2 from a PTX10008 Chassis
g100609
Figure 148: Removing a JNP10K-PWR-AC2 from a PTX10016 Chassis
g100607
6. Rotate the captive screw away from the faceplate of the power supply to release the latch.
7. Put on your heat protective gloves before removing the power supply from the chassis.
284