Figure 168: Installing a DC Power Supply in a PTX10016
g050733
Keep latch in open position during installation.
Close latch after power
supply is fully installed.
NOTE: Ensure that the ejector is fully open to avoid scratching the chassis.
g051046
YES
Ejector fully open
NO
Ejector closed
19. Route INP1 cables to a power source and INP2 to another power source. The JNP10K-PWR-DC shares
power, so if power dips on one input, the power supply is able to load balance internally. See
Figure 169 on page 306 and Figure 170 on page 306.
305
To Next Page
Loading...
