16. Slide the power supply straight into the chassis until the power supply is fully seated in the slot. Ensure
the power supply faceplate is flush with any adjacent power supply faceplates or power supply cover
panels (see Figure 167 on page 304 and Figure 168 on page 305).
17. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
18. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 167: Installing a JNP10K-PWR-DC Power Supply in a PTX10008
304
To Next Page
Loading...
