Juniper PTX10008 - Page 312

10. Install the plastic cable cover over each set of power cables by using the Phillips (+) screwdriver,
number 2, to tighten the screw.
11. If the power supply slot on the chassis has a cover on it, insert your thumb and forefinger into the finger
holes, squeeze, and pull the cover out of the slot. Save the cover for later use (see Figure 180 on page 316
and Figure 181 on page 316).
Figure 180: Removing the Power Supply Cover on a PTX10008
g100613
Figure 181: Removing the Power Supply Cover on a PTX10016
g100614
12. Unscrew the captive screw in the counterclockwise direction by using the Phillips (+) screwdriver,
number 1.
13. Rotate the captive screw away from the faceplate of the power supply to release the latch.
316