Figure 203: Removing the Cover Panel for a Line Card
CAUTION: Do not lift the line card by holding the edge connectors or the handles
on the faceplate. Neither the handles or the edge connectors can support the weight
of the line card. Lifting the line card by the handles or edge connectors might bend
them, which would prevent the line cards from being properly seated in the chassis.
See Figure 204 on page 340.
Figure 204: Line Card Connectors
1—Connectors
3. Remove the line card from the electrostatic bag and inspect it for any damage before installing it into
the chassis.
4. Grasp and lift the line card by the sides.
5. Slide the line card all the way into the slot until the handle holes align. See Figure 205 on page 341.
340
To Next Page
Loading...
