Juniper PTX10008 - Install Dual DC Power Supplies (JNP10 K-PWR-DC2)

Table 4: PTX10008 Hardware Configurations (continued)
Configuration ComponentsRouter Configuration
•
Chassis, including power bus
•
Two RCBs
•
Two fan tray controllers (JNP10008-FAN-CTRL or JNP10008-FTC2)
•
Two fan trays (JNP10008-FAN and JNP10008-FAN2)
•
Six DC power supplies (JNP10K-PWR-DC, JNP10K-PWR-DC2, or
JNP10K-PWR-AC2)
•
Six SIBs
•
Eight line card covers
Redundant DC configuration
PTX10008-PREMIUM
NOTE: You can install up to eight line cards (any combination of line cards) in the PTX10008.
NOTE: Line cards and the cable management system are not part of the base or redundant
configurations. You must order them separately.
NOTE: If you want to purchase additional power supplies (AC, DC, HVAC, or HVDC), SIBs, or RCBs
for your router configuration, you must order them separately.
SEE ALSO
PTX10000 Routing and Control Board Description | 78
JNP10K-PWR-AC Power Supply | 61
JNP10K-PWR-DC Power Supply | 65
PTX10008 Switch Interface Board Description | 86
36