Jura D6 - Initial Setup and Filter Insertion

12
1 Preparing and using for the first time
Precondition:The bean container has been filled.
T Insert the power plug into a power socket.
T Press the On/Off button Q to switch the D6 on.
LANGUAGE EN appears on the display.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
HARDNESS, 16°dH
E If you do not know the hardness of your water, you can find
this out first (see Chapter 1 ‘Preparing and using for the first
time – Determining the water hardness’).
T Turn the Rotary Switch to change the water hardness
setting, e.g. to
25°dH.
T Press the Rotary Switch.
OK appears briefly on the display.
INSERT FILTER
T Open the water tank cover.
T Remove the water tank and rinse it with cold water.
T Open the filter holder.
T Insert the CLEARYL Smart filter cartridge into the water tank,
exerting slight pressure.
T Close the filter holder. It will click into place audibly.
T Fill the water tank with fresh, cold water and reinsert the
tank.
E The machine automatically detects that you have just inserted
the filter cartridge.
OK appears briefly on the display.
OPEN SWITCH, the light segment on the switch lights up.
T Place a receptacle (at least 17 oz or 500 ml) under the fine
foam frother and the coffee spout.
T Turn the switch to them position.
FILTER RINSING, water flows out of the fine foam
frother.
E You can interrupt rinsing of the filter at any time. To do this,
turn the switch clockwise. Turn the switch anticlockwise to
continue rinsing the filter.
n nn n n n n n
cO n