24
4 Permanent settings in programming mode
Hot coffee, hot steam and hot water can cause scalding. Scalding is
a serious burn.
T Use extreme care when handling hot liquid or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area with cold water an
seek medical attention.
T Keep children AWAY.
In the program item
BUTTONS you can make individual,
permanent settings for all products:
Product Amount Coffee strength Temperature
Cappuccino
Water:
0.5 OZ – 8.0 OZ
(25 ml – 240 ml)
Milk foam:
3SEC.–60SEC.
MILD, NORMAL,
STRONG, EXTRA
NORMAL,
HIGH
Espresso
Water:
0.5 OZ – 2.5 OZ
(15 ml – 80 ml)
MILD, NORMAL,
STRONG, EXTRA
NORMAL,
HIGH
Coffee
Water: 0.5 OZ – 8.0 OZ
(25 ml – 240 ml)
MILD, NORMAL,
STRONG, EXTRA
NORMAL,
HIGH
Milk foam
Milk foam:
3SEC.–60SEC.
– –
Hot water
Water:
0.5 OZ – 15.0 OZ
(25 ml – 450 ml)
– –
2 cups When you prepare two specialty coffees at once, the temperature and amount
of water selected for the single product are used for each cup.
Permanent settings in programming mode always follow the same
model.
Example:Proceed as follows to change the coffee strength for one
coffee from
NORMAL to STRONG.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Turn the Rotary Switch until
BUTTONS is displayed.
T Press the Rotary Switch to enter the program item.
ESPRESSO
Product settings
J WARNING
To Next Page
Loading...
Need help?
General
Weight and Dimensions
