Jura D6 - Language

27
4 Permanent settings in programming mode
In the program item LANGUAGE you can set the language used
by your D6.
Example:Proceed as follows to change the language from
EN to
FR.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Turn the Rotary Switch until
LANGUAGE is displayed.
T Press the Rotary Switch to enter the program item.
EN
T Turn the Rotary Switch until FR is displayed.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
LANGUE
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
Language