15
2 Preparation
2 Preparation
Hot coffee, hot steam and hot water can cause scalding. Scalding is
a serious burn.
T Use extreme care when handling hot liquid or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area with cold water
and seek medical attention.
T Keep children AWAY.
Basic information about preparing drinks:
U
During the grinding operation you can select the coffee
strength of single products by turning the Rotary Switch:
MILD, NORMAL, STRONG or EXTRA.
U
During preparation, you can change the preset amounts (e.g.
amount of water or milk foam) by turning the Rotary Switch.
U
You can stop preparation at any time. Just press the Rotary
Switch (for a specialty coffee) or return the switch to its
original position (for milk foam and hot water).
U
The last specialty coffee prepared is always displayed, even if
the D6 was switched off in the meantime.
E The water volume is given as standard in ‘oz’. You can change
this setting to ‘ml’ in programming mode (see Chapter 4
‘Permanent settings in programming mode – Unit for amount
of water’).
Coffee tastes best served hot. A cold porcelain cup cools the
beverage – and impairs the taste. We therefore recommend
prewarming the cups. The full coffee aroma can develop only in
prewarmed cups. You can purchase a JURA cup warmer from your
specialized dealer.
You can make permanent settings for all products in programming
mode (see Chapter 4 ‘Permanent settings in programming mode –
Product settings’).
J WARNING
To Next Page
Loading...
