Jura D6 - Setting and Adjusting Water Hardness

25
4 Permanent settings in programming mode
T Turn the Rotary Switch until COFFEE is displayed.
T Press the Rotary Switch.
VOLUME
T Turn the Rotary Switch until STRENGTH is displayed.
T Press the Rotary Switch.
NORMAL
T Turn the Rotary Switch until STRONG is displayed.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
STRENGTH
T Turn the Rotary Switch until EXIT is displayed.
T Press the Rotary Switch to exit the program item.
COFFEE
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
The harder the water is, the more frequently the D6 needs to be
descaled. It is therefore important to set the water hardness
accurately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The water hardness can be adjusted on a continuous scale between
1
°dH and 30°dH.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Turn the Rotary Switch until
HARDNESS is displayed.
T Press the Rotary Switch to enter the program item.
16°dH
T Turn the Rotary Switch to change the setting.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
HARDNESS
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
Setting the water
hardness