Cha_oingtheDisplayBri htneS_ DIMMEB
d_ z !i,{_ _i!iia.¸ _g _.{' kd _'_¸ % ,_' &,> %.¸#¸¸¸
You carl dim the display window.
DIMMER-I-_DIMMER-2-'I
_(_ DIM OFF *----------J
"- _, (Canceled)
DIMMER-1 Dims the display illumination.
DIMMER-2 Erases the display illumination.
Setti}g theCIock ,:,
Without setting the built-in clock, you cannot use the Daily
Timer (see page 18).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1 Activate the clock setting mode.
LQi\/i_i -i_ l-_l ,-
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode (see
page 18) is selected.
2 Adjust the hour.
PRESETUP
PRESETDOWN
SET
3 Adjust the minute.
PRESETUP
(
PRESETDOWN'
SET
"CLOCK OK" appears and the built-in clock starts
working,
To check the current time during play
DISPLAY
, _ Clock
_ ,_t_____ Source information
If there is a power failure
The clock loses the setting and is reset to "AM 12:00." You
need to set the clock again.
{_:r{i]ngDII|he:Powe ,; ::;::, &,,,: :::::;:
_tGNatjcally ] ,',,
To turnoffthe Systemafterplaybackis over--
Auto Standby
A.STANDBY
When Auto Standby is in use, the A.STANDBY indicator
lights on the display.
m'7_ D
&STANDBY
When the disc playback stops, the A.STANDBY indicator
starts flashing.
If no disc operation is done for about 3 minutes while the
indicator is flashing, the System turns off (stands by)
automatically.
• Auto Standby only works after disc playback.
To turnoffthe Systemaftera certainperiod of
time--Sleep Timer
1 Specify the time (in minutes).
i'* 10_20 _30 _ 60 _90 _120 q
OFF <
""_ _ (Canceled)
2 Wait until the set time goes off.
To check the time remaining until the shut-off time
SLEEP I_) I
i t--i--
q,_c,: P ':'
- {,L,
2 SLEEP _
• If you press the button repeatedly, you can change the slmt-
off time.
14
To Next Page
Loading...
