e ecautiOn
Installation
• Install ill a place which is level, dry and neither too hot nor
too cold--between 5°C and 35°C (41 °F and 95°F).
• Install the System in a location with adequate ventilation to
prevent internal heat buildup inside the System.
• Leave sufficient distance between flae System and the TV.
• Keep the speakers away from the TV to avoid interference
wifla TV.
Power sources
• When unpluggiug the System from the wall outlet, always
pull on the plug, not the AC power cord.
A DO NOT handle tile AC power cord with wet )!
hauds
Moisturecondensation
Moisture may condense (m tile lenses inside the System ill
the following cases:
• After starting to heat the room
• Ill a danlp room
• If the System is brought directly from a cold to a warm
place
Should this occur, the System may malflmction. Ill this case,
leave the System turned on for a few hours until tile moisture
evaporates, unplug the AC power cord, then plug it ill again.
Internal heat
• A cooling fall is mounted (m tile rear panel to prevent heat
buildup inside file main unit (see page G-2).
For safety, observe the foUowing carefuUy:
• Make sure there is good ventilation around
the main unit. Poor ventilation could
• If you are not going to operate the System for an extended
period of time, unpklg the AC power cord fi'omthe wall outlet.
If auything goes wrong, unplug the AC power cord and
consult your dealer.
ThisMa ai
To make this manual as simple and easy-to-understaud as
possible, we have adapted the following methods:
• Button and control operations are explained as listed ill the
table below. Ill this manual, tile operations using tile remote
control is mainly explained; however, you call use the
buttons and controls on the main unit if they have tile same
(or similar) name and marks.
• Some related tips and notes are explained later in the
sections "Learning More about This System" and
"Troubleshooting," but not in the same section
explaining the operations. If you want to know more about
the functions, or if you have a doubt about the functions, go
to these sections and you will find the answers.
Indicates that you press the button
briefly.
Indicates that you press tile button
briefly and repeatedly until all option
you want is selected.
Indicates that you press one of fl_e
buttons.
Indicates that you press and hold tile
button for specified seconds.
• Tile number inside the arrow
indicates the period of press (ill this
example, 2 seconds).
• If no number is inside the arrow,
press and hold until the emire
procedure is complete or umil you
get a result you warn.
Indicates that you turn tile control
toward the specified direction(s).
Others
• Should ally metallic object or liquid fall into tile System,
unplug the AC power cord and consult your dealer before
operating ally further.
....................................................................................................................................................................................................................................................[ rJ
A DO NOT disassenlble the System since there
are no user serviceable parts inside.
Indicates that this operation is only possible
using tile remote control.
Indicates that this operation is only possible
using tile buttons and controls on tile main
unit.
2
To Next Page
Loading...
Need help?
General
