EN45
1
1
3
2
USING THE REMOTE CONTROL UNIT
The Full-Function Remote Control Unit can operate this
camcorder from a distance as well as the basic operations
(Playback, Stop, Pause, Fast-Forward and Rewind) of your
VCR. This remote control unit makes additional playback
functions possible.
Installing The Battery
The remote control uses one lithium battery (CR2025).
1
PULL OUT BATTERY HOLDER
Pull out the battery holder while pressing the knob as
shown.
2
INSERT BATTERY IN HOLDER
Insert the battery in the holder, and be sure to have
the “+” mark visible.
3
RE-INSERT HOLDER
Slide the holder back in until you hear a click.
•Read the caution concerning lithium batteries
(Z pg. 2).
Knob
5m
30°
30°
When using the remote control, be sure to point it
at the remote sensor. The illustration shows the
approximate transmitted beam effective area for
indoor use.
The transmitted beam may not be effective or may
cause incorrect operation outdoors or when the
remote sensor is directly exposed to sunlight or
powerful lighting.
Transmitted beam
effective area
Remote sensor
To Next Page
Loading...
Need help?
General
