EN75
TW
P
L
A
Y
/
P
C
O
F
F
C
A
M
E
R
A
5
S
D
S
C
D
S
C
P
L
A
Y
Power Switch
Digital Dubbing Of Recorded Images/
Sounds Between Tapes
It is also possible to copy recorded scenes from the
camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder’s power is off.
2
MAKE CONNECTIONS
Connect the camcorder to your video unit equipped
with a DV connector using the DV cable (optional) as
shown in the illustration.
3
START PLAYBACK
Press
4
to play back the source tape.
4
START RECORDING
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
(
Z
pg. 9).
●
When using the camcorder for dubbing, be sure to use it
as a player. The camcorder's DV connector is only for
output.
●
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.
●
If “Playback Zoom” (
Z
pg. 82), “Playback Special
Effects” (
Z
pg. 83), “Superimposing A Title/Frame”
(
Z
pg. 69) or “Snapshot” is attempted during playback,
only the original playback image recorded on the tape is
output from the DV OUT connector.
●
Be sure to use a DV cable with the core filter.
DV cable
(optional)
Video unit equipped
with DV connector
To DV IN
To DV OUT
Lock Button
PLAY (
4
)
STOP (5)
RM-V713U
(provided)
Open the
connector cover.
To Next Page
Loading...
Need help?
General
