7
8) Re-adjust the intensity of light using the focus control. Turn the focus control to
flood the light, to cover the area needed.
9) If necessary, adjust the barn doors to control the area of the light spill.
10) Turn the light off and repeat steps 5-9 for the other lights.
11) After adjusting all of the lights, turn them all on and check for shadows, dark
areas or other distractions and make additional lighting adjustments as necessary.
12) When you are satisfied with your lighting, turn off all of the lights until you are
ready to begin taping.
Note: Always wear gloves when making adjustments to a light that is on or was just turned off, as the instruments can be very hot.
To Next Page
Loading...
