21
Grip Belt Side:
14. Power Switch. Turns the camcorder on or off, and switches between video mode and still
picture mode.
16. Headphone Jack. Connect headphones to this jack to monitor the incoming audio during
recording, and to monitor the recorded audio during playback.
17. Microphone Jack. Connect a microphone to this jack if you are not using the included
microphone or the built-in microphone.
18. Input 1 Jack. Connect an XLR-equipped microphone cable to this jack. This signal
automatically goes to the CH-1 (Left) audio channel. You can also make this signal go to the CH-2
(Right) audio channel by setting the CH-2 Input switch to Input 1.
19. Input 2 Jack. Connect an XLR-equipped microphone cable to this jack. You must set the
CH-2 Input switch to Input 2 for this signal to be used at all.
To Next Page
Loading...
