JVC GY-HM170U - Viewing Recorded Videos Immediately (Clip Review)

Viewing Recorded Videos
Immediately
(Clip Review)
You can check (review) the last recorded video clip
on the screen.
However, the video clip cannot be played back if
the settings of the camera recorder are different
from the video format (Resolution/Frame Rate/Bit
Rate/SD Aspect) of the clip.
(A P115 [ W Resolution ] )
(A P115 [ W Frame Rate ] )
(A P115 [ W Bit Rate ] )
(A P116 [ SD Aspect ] )
Memo :
0
To
use this function, assign “Clip Review” to any
of the user buttons. “Clip Review” is assigned to
the [C.REVIEW/4] button in factory default.
0
“Clip
Review” can also be assigned to other user
buttons.
(A P39 [Assignment of Functions to User
Buttons] )
.
1
Press the user button assigned with the
“Clip Review
” function during standby
(“STBY” is displayed).
Playback of the configured section starts.
Memo :
0
The video clip is played back according to the
setting in [Main Menu] B [Camera Function] B
[User Switch Set
] B [Clip Review]. By default
setting (Last 5sec), the last 5 seconds of the clip
is played back.
(A P98
[ Clip Review ] )
0
When playback is complete, the camera
recorder exits Clip Review and returns to
“STBY” (recording standby) mode.
Caution :
0
During Clip Review, only the
[CANCEL] and
[REC] buttons are enabled.
Press the [CANCEL] button to cancel clip review
and return to “STBY” (recording standby) mode.
Press the [REC] button to cancel clip review and
enter recording mode. It will take some time to
start recording after the button is pressed.
0
When the last clip is less than 5 seconds, the
whole clip is played back.
0
Only
video clips in the currently selected slot can
be reviewed.
0
When there are no clips in the selected slot, Clip
Review function is disabled.
0
Clip Review is unavailable when Clip
Continuous Rec is paused (“STBYC”, yellow
text). To operate Clip Review, use the
[CANCEL] button to set to “STBYC” (white text)
first.
(A P
79 [Clip Continuous Rec] )
0
Clip Review is unavailable when the camera
recorder
is connected to an external equipment
and the equipment is in recording state.
0
Clip Review is unavailable when operating View
Remote via network connection.
(A P158 [View Remote Feature K] )
0
Clip Review does not function during live
streaming. K
0
Clip Review does not function while SDI Rec
Trigger is in the REC state. K
Viewing Recorded Videos Immediately (Clip Review)
73
Shooting