JVC GY-HM170U - Frame Rec

Memo :
0
Clip Continuous Rec cannot be used in the
following cases.
0
When [Main Menu
] B [System] B [Record
Set] B [System] is set to “HD” or “SD”, and
[Format] is set to “AVCHD”
0
When [
Main Menu] B [System] B [Record
Set] B [System] is set to “HD+Web”
0
The following operations cannot be performed
while
recording is paused (STBYC, yellow text).
0
Clip Review operation
(A P73 [Viewing Recorded Videos
Immediately (Clip Review)] )
0
Switching SD card slots
0
Switching operation mode
(A P18 [Operation Modes] )
0
Files are split into sizes of 4 GB (or 30 minutes)
regardless of the menu settings.
Caution :
0
Do not remove the SD card during recording
(RRECC, red text) or recording pause
(STBYC, yellow text).
0
To remove the SD card in the
“Clip
Continuous” mode, press the [CANCEL] button,
check that “STBYC” (white text) is displayed
and the card slot status indicator lights up in
green before you remove the card.
0
When the SD card becomes full during
recording, recording stops and
“STOP” is
displayed.
0
When
the [POWER ON/OFF] switch is turned off
during recording or recording pause, recording
stops and power is cut off after a clip is
generated.
0
If the power is cut off due to low battery power,
a proper clip may not be generated.
0
When [WFormat]/[YFormat] in the [
Main
Menu] B [System] B [Record Set] B [Record
Format] menu is set to “AVCHD”, Clip
Continuous Rec cannot be performed.
(A P
115 [ W Format ] )
(A P115 [ Y Format ] )
Frame Rec
In normal recording, when the recording stops, the
image
and accompanying data from the start till the
end of the recording are recorded as one “clip” on
the SD card.
In this mode, recording starts with every press of
the [REC] button, and only the specified number of
frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
0
Audio will not be recorded.
0
Until a specified amount of recordings is
accumulated, the file cannot be written to the
media.
0
If the specified amount is not reached when
recording is stopped, normal recording is
performed and frames are added to the ending
of
the clip until the amount is reached. (Padding)
0
After the specified number of frames is recorded
and written to the media, recording will be
performed until the same number is
accumulated again.
.
Specific amount of data
Actual clips recorded to the media
Records number of frames specified in [Rec Frames]
(Padding data)
Normal recording
PausePausePause
Recording resumes Recording resumes
Press [REC]Press [REC]
(Frame Rec stops)(Frame Rec starts)
Press and hold [REC]Press [REC]
1
Set [Rec Mode] to “Frame Rec”.
0
Set [Main Menu
] B [System] B [Record
Set] B [Rec Mode] to “Frame Rec”.
(A P
116 [ Rec Mode ] )
0
The display changes (“STBY” B “STBYM”).
80
Special Recording
Shooting