JVC GY-HM170U - Interval Rec

2
Set the number of frames to record in [Rec
Frames
].
0
Set
using [Main Menu] B [System] B [Record
Set] B [Rec Mode] B [Rec Frames].
(A P116
[ Rec Frames ] )
3
Start recording.
0
Press the [REC] button to record only the
number of frames specified in [Rec Frames]
and pause.
0
The display changes (“STBYM” B “RRECM”
B “STBYM” (yellow text)).
0
The card slot status indicator lights up in
green.
4
Repeat Frame Rec.
0
Press the [REC] button again to record only
the number of frames specified in [Rec
Frames]
and pause.
0
The display changes (“STBYM” B “RRECM”
B “STBYM” (yellow text)).
0
Frame Rec continues until the recording is
stopped (step 5).
5
Press and hold the [REC] button.
0
The card slot status indicator lights up in
green.
Caution :
0
Do not remove the SD card during recording
(“RRECM”, red text) or recording pause
(“STBYM”, yellow text).
0
To
remove the SD card during Frame Rec, press
the [CANCEL] button, check that “STBYM”
(white text) is displayed and the card slot status
indicator lights up in green before you remove
the card.
0
When [Main Menu
] B [TC/UB] B [TC
Generator] is set to “Free Run”, the time code
will be recorded in “Rec Run”.
0
Audio cannot be recorded. The audio level
meter is grayed out.
(A P128
[Audio Level Meter] )
Interval Rec
In normal recording, when the recording stops, the
image
and accompanying data from the start till the
end of the recording are recorded as one “clip” on
the SD card.
In this mode, recording and pause are performed
repeatedly at the specified time interval. Only the
specified number of frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
0
Audio will not be recorded.
0
Until a specified amount of recordings is
accumulated, the file will not be written to the
media.
0
After
the specified number of frames is recorded
and written to the media, recording will be
performed until the same number is
accumulated again.
0
If the specified amount is not reached when
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip until the amount is reached. (Padding)
.
Specific amount of data
Actual clips recorded to the media
Records number of frames specified in [Rec Frames]
(Padding data)
Normal recording
PausePausePause
[Rec Interval][Rec Interval]
Recording resumes Recording resumes
(Interval Rec stops)(Interval Rec starts)
Press [REC]Press [REC]
1
Set [Rec Mode] to “Interval Rec”.
0
Set [Main Menu] B [System] B [Record
Set] B [Rec Mode] to “Interval Rec”.
(A P
116 [ Rec Interval ] )
0
The display changes (“STBY” B “STBYN”).
2
Set the number of frames to record in [Rec
Frames
].
Set using [Main Menu] B [System] B [Record
Set] B [
Rec Mode] B [Rec Frames].
(A P116 [ Rec Frames ] )
Special Recording
81
Shooting