JVC GY-HM170U - Special Recording; Pre Rec

Special Recording
Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Select a mode from
[Main Menu] B [System] B
[Record Set] B [Rec Mode].
(A P116 [ Rec Mode ] )
Memo :
0
When [Main Menu] B [System] B [Record Set] B
[Record Format] B [ W Format] is set to “AVCHD”,
“Clip Continuous” cannot be selected.
(A P115 [
W Format ] )
0
When [Main Menu] B [System] B [Record Set] B
[Record Format] B [System] is set to “HD+Web”,
special recording cannot be selected
Pre Rec
0
By
setting the number of seconds in the [Pre Rec
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
0
When
starting actual recording while the camera
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
0
Using Pre Rec allows you to record a complete
event without missing the initial scenes even if
you start the recording late.
Memo :
0
Pre Rec Time can be set in
[Main Menu] B
[System] B [Record Set] B [Rec Mode] B [Pre
Rec Time].
The following values can be selected depending
on the setting of [Main Menu] B [System] B
[Record Set] B [Record Format] B [System].
0
When [System] is set to
“4K”:
Fixed at “5sec”
0
When [
System] is set to “HD” or “SD”:
“5sec”, “10sec” or “15sec”
(A P116
[ Pre Rec Time ] )
.
(Recording stops)
Press [REC]
(Recording starts)
Press [REC]
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
(Recorded video and audio)
Completed Clip
1
Set [Rec Mode] to “Pre Rec”.
(A P
116 [ Rec Mode ] )
0
Set [Main Menu] B [System] B [Record
Set] B [Rec Mode] to “Pre Rec”.
0
The display changes (
“STBY” B “STBYP”).
2
Press the [REC] button to start recording in
Pre Rec mode.
0
The display changes (“STBYP” B
“RRECP”)
and the card slot status indicator
lights up in red.
0
Press the [REC] button again to pause
recording. The display changes (“RRECP”
B “STBYP”) and the card slot status
indicator lights up in green.
Caution :
0
When the interval between start and stop
recording is short, “STBYP” may not be
displayed immediately after recording is
complete.
“RRECP” B “STBYP”
(“STBY” blinks in red) B
“STBYP” is displayed.
0
When the SD card becomes full during
recording, recording stops and
“STOP” is
displayed.
0
In the following cases, video and audio before
the
specified Pre Rec time may not be recorded
even if recording starts.
0
Immediately after power on
0
Immediately after recording stops
0
Immediately after switching from Media
mode to Camera mode
0
Immediately after setting
[Rec Mode]
0
Immediately after the end of Clip Review
0
Immediately after changing file format
0
Immediately after changing video format
78
Special Recording
Shooting