Filename [XVS30EK_06Index.fm]
Masterpage:Left0
12
Page 12 September 11, 2003 9:07 am
INITIAL SETTINGS
Auto Set Up
Auto Channel Set/Auto Clock Set/
Auto Guide Program Number Set
A
Turn on the unit.
Press 1 on the unit or remote control.
B
Perform Auto Set Up.
The AUTO SET/T-V LINK display appears on the front
display panel and/or on the TV screen.
On the front display panel
Press rt to select “AUTO”
and press OK or e.
● When you have connected the unit to a TV offering T-V Link
via a fully-wired 21-pin SCART cable (
墌 pg. 11) and the TV is
turned on, the unit automatically performs the Preset
Download (
墌 pg. 13) even if you select “AUTO” or “AUTO
SET” for Auto Set Up function.
C
Confirm/Set video channel.
With RF Connection
The video channel that is
shown on the display panel is
your video channel. Press OK.
● To view picture signals from the unit, set your TV to the video
channel.
With AV Connection
Press PR – until the display
panel shows “CH – –”. Now
the video channel is set to off. Then press OK.
● To view picture signals from the unit, set your TV to its AV
mode.
NOTES:
● In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto
Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP MENU
while Auto Set Up is in progress, Auto Set Up will be
interrupted; be sure to turn off the unit power once and try
again from step A.
● Auto Clock Set may not function properly depending on the
reception condition.
After the 1 button on the unit or remote control is pressed
for the first time to power on the unit
, the Auto Set Up
function sets the tuner channels, clock and Guide Program
numbers automatically.
Before starting, make sure of the following:
● The TV aerial cable should be connected to the unit.
● The unit’s mains power cord should be connected to a
mains outlet.
● The TV should be set to its AV mode (with AV connection
墌 pg. 11) or UHF channel 52 (with RF connection
墌 pg. 11).
● Slide the TV/VCR/DVD switch to the right.
On the on-screen display
Press rt to move the
highlight bar (pointer) to
“AUTO SET” and press OK or
e.
While Auto Set Up is in progress, do NOT press any
button on the unit or remote control until the front
display panel shows either the display as illustrated in
step C or “– –:– –” as illustrated on page 14.
● If you are using the on-screen
display, the AUTO SET
screen will appear. As Auto
Set Up progresses, the “q”
mark on the TV screen
moves from left to right.
ATTENTION
Once you have performed Auto Set Up, even if the unit’s
memory backup has expired, all the stored stations and their
Guide Program numbers remain in the unit’s memory and
the unit will not perform Auto Set Up again. The unit
performs only Auto Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
● Video channel setting (for RF connection users)
墌 pg. 75
● Tuner setting
墌 pg. 70
● Clock setting
墌 pg. 76
If a new station starts broadcasting in your area, perform
tuner setting (
墌 pg. 70) and, if necessary, video channel
setting (
墌 pg. 75).
After “Auto Set Up” is completed, perform “Monitor
Set (DVD deck)” on page 15.
Beginning End
XVS30EK_06Index.fm Page 12 Thursday, September 11, 2003 9:07 AM
To Next Page
Loading...
Need help?
General
