Filename [XVS30EK_10Subsidiary.fm]
Masterpage:Left0
64
Page 64 September 2, 2003 4:59 pm
SUBSIDIARY SETTINGS
Mode Set (S-VHS deck)
You can change various mode settings on the Mode Set
screen by following the procedure described below.
● For each mode setting, see pages 64 to 66.
A
Turn on the unit.
Press 1.
B
Select the S-VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
C
Access the Main Menu screen.
Press SET UP MENU.
D
Access the Mode Set screen.
E
Select the mode.
Press rt to move the highlight bar (pointer) to the item
you want to change.
F
Select the mode setting.
Press OK or e.
G
Return to the normal screen.
Press SET UP MENU.
* The default setting is bold in the table below.
8 S-VHS ET — ON / OFF
You can record in SP mode on VHS cassettes with S-VHS picture
quality. You can play back a tape recorded using the S-VHS ET
function on most S-VHS recorders and VHS recorders equipped
with the SQPB (S-VHS QUASI PLAYBACK) function. (Notice
some recorders are not compatible with the S-VHS ET function.)
When this function is set to “ON”, the S-VHS indicator lights up
on the front display panel.
NOTES:
● You can activate the S-VHS ET function only before you start
recording on a VHS cassette.
● Before recording, make sure that “B.E.S.T.” is set to “ON”. (
墌
below)
● You cannot activate the S-VHS ET function:
— while recording is in progress.
— while timer-recording or Instant Timer Recording
(
墌 pg. 22, 24, 26) is in progress.
— while B.E.S.T. (
墌 pg. 23) is in progress.
● The S-VHS ET function does not work:
— with S-VHS cassettes.
— with recordings in LP/EP mode.
● To keep the highest quality recording and playback pictures
over a long period of time, S-VHS recording on S-VHS
cassettes is recommended.
● Use of high grade tapes is recommended for S-VHS ET
recordings. On some tapes, picture quality will not improve
even if the S-VHS ET function is used. Check the recording
quality before you start important recordings.
● While playing back a tape recorded using the S-VHS ET
function on some recorders, noise may appear. (If playback
picture becomes blurred or interrupted, use a cleaning
cassette.)
● In the high-speed search, still, slow-motion or frame-by-frame
playback modes (
墌 pg. 19), noise may appear. If these modes
are performed frequently on a tape recorded using the
S-VHS ET function, the tape may be damaged and the picture
may be deteriorated.
● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
Press rt to move the
highlight bar (pointer) to
“MODE SET”, then press OK
or e.
XVS30EK_01.book Page 64 Tuesday, September 2, 2003 5:01 PM
To Next Page
Loading...
