w
arning message pops up, the recording process stops and it will keep on the
41
e)
I
f the signal is not stable there may be some pause;
f)
The recording progress will stop when the device has no more free spaces if there is no setting about
when to end before. A
normal playback process. Otherwise the progress ends naturally when the timer is timeout. Also user
could press KEY_STOP to end recording
manually;
(
REC info and stop recording window)
g)
System will prompt user error message and try to continue recording if there are some bad tracks in
disk.
3.2
T
imer REC
T
here are two methods to set a timer. As follows:
1.
In the EPG menu user can preengage programs
for
watching or recording;
a)
Pressing
KEY_GREEN
once
is to preengage the program
only for watching（when timeout, it jumps to
the program
and only play.
b)
Pressing
KEY_GREEN
twice
is to preengage the program
for recording (when timeout, it jumps to the
program
and starts recording). if it is timeout in standby mode, it will power on 2 minutes in advance
and starts to record under background without powering on the panel. To watch the program, user need
to press KEY_POWER;
c)
The preengaged programs can be checked in Timer menu.
(Pre
ss KEY_GREEN once
for
reminder)
To Next Page
Loading...
