vii
Warnings
To prevent an accidental fall
When fixing to furniture
1 Thread a belt (not supplied) through the hole on the
back of the stand.
2 Fix the belt to the furniture using a screw.
FCC Notice:
Caution: Changes or modifications not expressly approved by party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
WX70instus.indbviiWX70instus.indbvii 09.3.65:14:30PM09.3.65:14:30PM
To Next Page
Loading...
Need help?
General
