JVC RX-316BK - Features; About this Manual

€-1 (00G0Z “ON)
Troubleshooting
Page 20
Use this chart to help you solve everyday operational problems. If there is any problem you
cannot solve, contact your JVC service center.
PROBLEM
Display window does not
light up
POSSIBLE CAUSE
Power cord not plugged in
SOLUTION
Plug power cord into AC socket
Introduction
No sound from speakers
Speaker wires not connected
Check speaker wiring and
reconnect if necessary
SPEAKERS buttons not set
correctly
Push the SPEAKER Sbuttons
in or out as desired
Incorrect SOURCE button
was pressed
Select the correct audio source
Sound from one speaker only
Continuous hiss or buzzing
during FM reception
Speaker wires not connected
properly
Balance control is set to one
extreme
Incoming signal is too weak
Check speaker wiring and
reconnect if necessary
Adjust BALANCE conwol so that
both speakers have sound
Adjust antenna
Station is too far away
Incorrect antenna used
Select a new station
Check with your dealer to be sure
you have the correct antenna
Antenna not connected
properly
Check connections
Occasional cracking noise
during FM reception
Ignition noise from
automobiles
Move the antenna farther from
automobile traffic
Howling during record
playing
Turntable too close to
speaker
Move speakers away from
turntable
Remote control does not
work
There is an obstruction in
front of the REMOTE
SENSOR on the receiver
Remove the obstruction
Batteries are weak Replace batteries
Thank you for purchasing the JVC RX-317TN receiver. We hope it will be a valued addition
to your audio system. Be sure to read these instructions carefully before installing and operating
the receiver.
Features
¢ Monitor recording quality
Surround feature with two or four speakers
Remote control
Preset radio stations
Easy to use
About This Manual
This manual gives you the basic information you need to install and use your receiver. It
explains everything you need to know from turning the power switch on to basic troubleslioot-
ing. Please consult your SVC dealer if you have further questions about the receiver.
The following conventions are used in this manual:
* Controls, buttons, and connection points on the back of the receiver are indicated with
capital letters, like this: POWER button, AUDIO jacks
* Messages that appear on the display window are indicated with capital letters and in quotes,
Jike this: “TUNED”
.
Instructions that you need to follow to get the correct results are labeled IMPORTANT!
* Helpful information is labeled NOTE:
* To avoid electric shock to yourself or damage to the receiver, read the information labeled
Av CAUTIONI
Page 1
NIZLE-XY
Ma9le-xXY