JVC RX-5022RSL

28
Operating JVC’s Audio/Video Components
COMPU LINK Remote Control System / Operating JVC's Audio/Video Components
You can use the remote control to operate other JVC’s
components.
Operating Audio Components
IMPORTANT:
To operate JVC’s audio components using this remote control:
• You need to connect JVC’s audio components through the COMPU
LINK (SYNCHRO) jacks (see page 27) in addition to the
connections using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 8.)
• Refer also to the manuals supplied with your audio components.
Sound Adjustment
You can always perform the following operations:
SURROUND ON/OFF : Turn on or off the Surround modes.
SURROUND MODE : Select the Surround modes.
After pressing SOUND, you can use the following buttons for sound
adjustment:
SUBWOOFER +/– : Adjust the subwoofer output level.
CENTER +/– : Adjust the center speaker output level.
REAR•L +/– : Adjust the left rear speaker output level.
REAR•R +/– : Adjust the right rear speaker output level.
EFFECT : Select the DAP effect level.
TEST : Turn on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DISC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always perform the following operations:
FM/AM : Alternate between FM and AM (MW/LW).
FM MODE : Change the FM reception mode.
After pressing FM/AM, you can use the following buttons for tuner
operations:
1 – 10, +10 : Select a preset channel number directly.
• For channel number 5, press 5.
• For channel number 15, press +10, then 5.
• For channel number 20, press +10, then 10.
DISPLAY MODE : Shows the RDS signals.
PTY SEARCH : Searches for a program by PTY codes.
PTY +/ – : Selects the PTY codes.
TA/NEWS/INFO : Selects a broadcast program type.
FM MODE
A/V CONTROL
RECEIVER
STANDBY/ON
AUDIO
TV
VCR
DVD
TEST
EFFECT
MENU
ENTER
RETURN
SOUND
SLEEP
REAR L
SUBWOOFER
TA/NEWS/INFO
PTY–PTY SEARCH–PTY
DISPLAY MODE
CD
–
DISC
REC PAUSE
TAPE/CDR CD DVD
FM/AM
FM MODE
DIMMER TV/VIDEO
SURROUND
ON/OFF
MODE
MUTING
VCR CH
TV CH
TV VOLUME
VOLUME
TV SOUND VCR
ANALOG
/DIGITAL
REAR R
100
1
4
7/P
10
2
5
8
0
3
6
9
10
REMOTE CONTROL RM - SRX 5022R
REW
FF
CENTER
EN27-32.RX-5022RSL[B]_f 02.1.16, 5:34 PM28