Sound Adiustments
/
w
e_
q,n
o
L
L
i"
¢D
Once each of following settings has been adjusted, this receiver
memorizes the adjustment for each source.
When the input level of the analog source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
I Press and hold INPUT ATT (INPUT _ _
ANALOG) so that the INPUT ATT _'_
indicator lights up on the display.
• Each time you press and hold the button, the Input Attenuator
mode turns on ("INPUT ATT ON") or off ("INPUT
NORMAL").
Press ADJUST repeatedly until "BASS" *DJOST
or "TREBLE" (with the current _'_
setting)* appears on the display.
* "0" is the initial setting. If you have already changed the
setting, another number (level) will be shown.
TREBLE : To adjust the treble (-10 to +10).
2 Press CONTROL UP A/DOWN • to C0.TROL
DOWN UP
adjust the bass or treble sounds level. I
• Each time you press the button, the sound
level changes by +2 steps.
_i PI_ __ ["_im;l )_I
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speakers output balance.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
Press ADJUST repeatedly until _D_OST
"BALANCE"
(with the current setting)* _'_
appears on the display.
* "CNTR" (Center) is the initial setting. If you have already
changed the setting, another setting will be shown.
2 Press CONTROL UP A/DOWN • DOg_#TR%
to adjust the balance. I
• Pressing CONTROL UP • decreases the
left channel output from "CNTR" (Center) to
'%-21 ."
• Pressing CONTROL DOWN • decreases
the right channel output from "CNTR" (Center) to "R-21."
You can adjust the bass and treble sounds as you like.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
You can adjust the subwoofer output level if you have connected a
subwoofer and set the subwoofer information correctly--"YES."
Onthefrontpanel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
Press ADJUST repeatedly until _DJOST
"SUBWFR (Subwoofer)" (with the _<_
current setting)* appears on the
display.
* "0" is the initial setting. If you have already changed the
setting, another number (level) will be shown.
2 Press CONTROL UP A/DOWN • to
adjust the subwoofer output level
(-10 to +10).
Fromthe remotecontrol:
Press SOUND.
The 10 keys are activated for sound adjustments.
2 Press SUBWOOFER +/- to adjust
the subwoofer output level (-10 to
+10).
Note:
CONTROL
DOWN UP
I'@
-- SUBWOOFER"I"
©@
Subwoofer output level cannot be adjusted when using headphones.
15
To Next Page
Loading...
Need help?
General
