Masterpage:Right-NoTitle0
EN
53
Filename [VS30U_3-EN.fm]
Page 53 January 31, 2002 3:40 pm
Tape Dubbing
(from VHS to DV)
Dubbing An Entire Cassette
Because this VCR includes both VHS deck and DV deck, you
can easily use it for dubbing without connecting any other
equipment.
A
Load cassettes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab removed.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “REC”.
B
Select the dubbing direction.
Press .
● The dubbing direction indicator ( S-VHS) lights.
C
Set the tape speed.
Press
DV
, then press
SP/LP (
p
)
.
● “VHS ]
DV” appears on the TV screen if “SUPERIMPOSE” is
set to “ON”. (
墌
pg. 71)
D
Start dubbing.
Press
DUB
for more than 2 seconds.
● VHS playback indicator and DV recording indicator light.
● If the tapes have not been rewound, both decks rewind
automatically. The DV deck goes into Record Pause mode, and
the VHS deck goes into Pause mode.
When both decks have finished rewinding, dubbing begins
automatically.
After dubbing is completed, the decks rewind both tapes
automatically and eject them. The VCR then shuts off.
NOTES:
● If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to copy. It is
recommended to conduct a test with unimportant cassettes
first.
● If you start dubbing a copy-protected tape, “ERROR” message
is displayed on screen and the dubbing is aborted.
● To cancel the dubbing mode, press
CH +/–
so that the
dubbing direction indicator ( S-VHS) goes off.
1
32
123
456
7
89
0
2
4
1
3
T W
DV S-VHS
VS30U_3-EN.fm Page 53 Thursday, January 31, 2002 3:40 PM
To Next Page
Loading...
Need help?
General
