Filename [VS30U_3-EN.fm]
Masterpage:Left
58
EN
Page 58 January 31, 2002 3:40 pm
EDITING (cont.)
Edit To Or From
Another VCR/PC
You can use your VCR as the source player or as the
recording deck.
A
Make connections.
Connect an audio/video cable between the player’s
VIDEO OUT and AUDIO OUT connectors and the
recorder’s VIDEO IN and AUDIO IN connectors.
● If connecting a VCR with an S-VIDEO input/output connector,
it is recommended to use the S-VIDEO connection to
minimize picture degradation while editing.
B
Set the input mode of recording deck.
If using your VCR as a recording deck, press
AUX
(
number key
“
0
”) and/or
CH +/–
to select “L-1”.
L-1: when connecting the VCR to the audio/video input
connectors on the rear panel.
● When using S VIDEO connector, set “REAR AUX INPUT” to
“S-VIDEO”. (
墌
pg. 71 )
● When using VIDEO connector, set “REAR AUX INPUT” to
“VIDEO”. (
墌
pg. 71)
C
Select the recording deck.
Press
S-VHS
or
DV
.
D
Set the edit mode. (VHS deck only)
See “PICTURE CONTROL” on page 73.
E
Start the source player.
Engage the Play mode of the source player.
F
Start the recording deck.
Engage the Record mode of the recording deck.
123
456
7
89
0
2
4
1
3
T W
DV S-VHS
VS30U_3-EN.fm Page 58 Thursday, January 31, 2002 3:40 PM
To Next Page
Loading...
