XV-N5SL
11
3.1.3 Removing the traverse mechanism assembly
(See Fig.4 and 5)
• Prior to performing the following procedure, remove
the clamper assembly and the tray.
(1) Remove the four screws B attaching the traverse
mechanism assembly.
ATTENTION:
Before reattaching the traverse
mechanism assembly, pass the card
wire extending from the spindle motor
board through the notch d of the elevator.
Fig.4
Fig.5
3.1.4 Removing the elevator
(See Fig.6)
• Prior to performing the following procedure, remove
the clamper assembly, the tray and the traverse
mechanism assembly.
(1) Extend each bar e inside of the loading base
outward and detach the elevator shaft.
ATTENTION:
When reattaching, first fit the two shafts on the
front of the elevator to the slots f of the slide cam.
Fig.6
To Next Page
Loading...
Need help?
General
