805.1
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
General Information
Overview
Introduction:
K-Cdr
The following pages describe the K-Commander (K-Cdr ) pages or
screens for the loss-in-weight application. A listing of menu selections is
provided for each screen. This document is suitable for rev. Z software.
In this chapter
Please note that the page numbers beginning with 01 is merely to give
reality to the display and this number could range from 01 to 15.
Definitions
Here is a listing of common terms used in loss-in-weight feeding.
Term Definition
Adaptive Tuning This is a control concept that when
implemented, the controller continues to
optimize its operation , zeroing in, if you will
on the best point of control.
Density Array
A group of FeedFactors that are placed in an
array from Refill Complete to Refill Request.
The values in the array are used to operate
the feeder during Refill.
Drive Command This is the frequency output of the LWF K10S
controller that normally provides the setpoint
signal to the MDU or motor drive unit. The
larger the value of drive command, the
greater the feedrate should be. Maximum
operating value of Drive Command is 100%.
Continued on next page
To Next Page
Loading...