In power saving mode, the video intercom function is
stopped. When the battery power of the door lock reaches
a certain low level, the door lock will automatically start
the power-saving mode. If the video intercom function
needs to be enabled again, please replace the fully charged
battery, then automatically exit the power-saving mode
and resume the video intercom function.
Turn on/off automatic mode
Press 1 to enter user settings, then press 5 to enter deleting
user, and press 2 to delete all user PIN code, voice prompt:
Deletion successful, PIN code database is empty.
Press 1 to enter user settings, then press 5 to enter deleting
user, and press 3 to delete all user fingerprints, voice prompt:
Deletion successful, fingerprint database is empty.
Turn on/off Dual-verification
In Master mode:
Press 1 to enter user settings, and then press 6 to turn on
(or off) Dual-verification, voice prompt: Setup successful,
turn on (or off) Dual-verification.
In Master mode:
Press 1 to enter user settings, and then press 7 to turn on
(or off) automatic mode, voice prompt: Setup successful,
automatic mode/manual mode.
Turn on/off power saving mode
In Master mode:
Press 1 to enter user settings, and then press 8 to turn on
(or off) power saving mode, After the setting is successful,
the smart lock enters the power saving mode.
In Master mode:
Press 2 to enter Language Settings, Press 1 to select
Chinese, press 2 to select English.
Language settings
or
Network configuration
In Master mode:
Press 4 to enter Network configuration Settings, voice
prompt: Network configuration settings entered, perform
network configuration operation according to the guidance
of APP. This lock only support 2.4Ghz WiFi frequency and
does not support 5Ghz frequency. Make sure distance
between router and lock not exceed 10m, otherwise weak
signal may affect connection effect.
Pre-network configuration, please scan QR code to
download and install APP. Please complete registration if
use this APP first time. Open APP home page after sign
in successfully, click “+" at top-right corner, select "scan
code to add", then scan the QR code on the back of the
battery cover to add the device.Please follow the guide
of APP for network configuration operation.
To Next Page
Loading...
