Kaiser Baas WiFi Photo & Document Scanner - From Apple Mac; From Windows devices

23
22
From Windows devices
1. Press iScan Air app. Swipe in from the right side or move the cursor
to the upper-right or lower-right of your device’s screen to reveal the
menu bar, then select the Calibrate setting
2. Remove the plastic foil on the calibration card, insert it in the feed slot
with the arrow mark facing up and pointing to scanner
3. Press Calibrate button
The calibration card will automatically feed into the scanner, and the
WiFi LED indicator will blink pink on the scanner. Wait until the card is
ejected completely. A ‘Calibration done’ message will appear on the
app. Select Close button
4. If lines still appear, clean the roller and clean the lens then repeat
calibration procedure.
CALIBRATION
From Apple Mac
1. Press iScan Air app. Press the Settings at the top-left corner of the
Mac’s screen to reveal the menu, then select the Calibrate setting
2. Remove the plastic foil on the calibration card, insert it in the feed slot
with the arrow mark
3. Press the Calibrate button
The calibration card will be pulled into scanner, and the WiFi LED
indicator will blink pink light during calibrating. Wait until the calibration
card is ejected with a ‘Calibration done.’ message. Press the OK button
4. If lines still appear, clean the roller and clean the lens then repeat
calibration procedure.
MacBook Pro
CALIBRATION
Note: It’s advised to do a calibration procedure periodically Note: It’s advised to do a calibration procedure periodically.