Kaiser Baas WiFi Photo & Document Scanner - From Windows phone devices; Care

To Next Page

To Previous Page

From Windows phone devices

1. Press iScan Air app. Press the settings icon at the bottom-right

corner to reveal the menu, then select the Calibrate setting

2. Remove the plastic foil on the calibration card, insert it in the feed slot

with the arrow mark facing up and pointing to scanner

3. Press Calibrate button

The calibration card will be pulled into scanner, and the

WiFi LED indicator will blink pink light during calibrating. Wait until the

calibration card is ejected with a ‘Calibration done.’ message, then

press the ok button

4. If lines still appear, clean the roller and clean the lens then repeat

calibration procedure.

CALIBRATION

Dirt and stains can build up on the scanner’s rollers and affect image quality,

clean the scanner’s rollers periodically to get the best result. Use the

cleaning board included with scanner to clean rollers

From iPad, iPhone and iPod touch

1. Press iScan Air app. Press the Settings at the top-right corner of

the app to reveal the menu, then select the Clean setting

2. Hold the foam strip of cleaning board facing down, gently insert it into

the feed slot

3. Press the Clean button

4. The cleaning board will be pulled into scanner, and the WiFi LED

indicator will blink pink light during cleaning. Wait until the cleaning

board is ejected with a ‘Cleaning done.’ message. Press the OK button

CARE - CLEAN ROLLERS

POWER

Note: It’s advised to do

a calibration procedure

periodically.

Note: Advisable to

clean rollers periodically

using this procedure.

Kaiser Baas WiFi Photo & Document Scanner - From Windows phone devices; Care - Clean Rollers