Bladder Volume Tester User’s Manual V1.02
- 24 -
12.3 Replace the thermal paper
Built-in printer is the thermal printer, which uses thermal paper. If the thermal paper needs to be
replaced, you can purchase in accordance with the company's specified model (57*40mm).
Replacement of thermal paper:
1. Turn off the main unit;
2. Press the “PUSH” button on the front panel to open the cover of thermal printer;
3. Hold down the round button to open the thermal printer’s front cover, remove the remaining paper
core from the paper washhouse;
4. Put the new thermal paper into the center position, the thermal paper exposing the paper warehouse
3cm, and then close the front cover.
12.4 Replace the fuse
Replace the fuse is to replace the power adapter.
12.5 Use and maintenance for the rechargeable battery
1. The battery pack (model RK-HYLB-1676) is charged within main unit or with charger (model
RKU10) provided by Kaixin Company. Service personnel or operator can replace the battery
pack.
2. Plug the output port of adapter into the input port of charger to charge the battery; the charging
time is about 5 hours. Over-charging or discharging will shorten the battery life; the full charged
battery usually can be used for 7 hours.
3. Battery is consumable; the battery cycle-life is based on the times of charge and discharge as unit.
When the use time reduced significantly compared with normal conditions, the battery should be
promptly replaced.
4. The excess high or low temperature will affect the charging and discharging performance, and
short the battery life and capacity.
Attention:
Battery charger shall meet the requirements of the IEC60601-1 standard.
Attention:
1.
When closing the front cover, make sure that the paper exposed a section from the paper
exit, allow the roll axis to fully suppress the paper, otherwise it can not be printed.
2.
When placing thermal paper, make sure that the thermal coating of thermal paper on the
top, and then put the thermal paper into the paper washhouse. If the thermal coating is
not on the correct surface, the writing will not be printed. If the paper appears deviation,
you can re-open the front cover and adjust the paper position.
3.
Note that when replacing the thermal paper if there is paper, dust on the print-head, if
has gently removed it.
Attention:
1. The fuse is inside the power adapter. Fuse shall be replaced by qualified service personnel
who get Kaixin approval.
2. Before replacing the fuse, please contact Kaixin and replace it under the guidance of
Kaixin.
3. Before replacing the fuse, you must disconnect the mains supply from the mains supply.
4. Fuse Type: T3.15AH250VAC.
To Next Page
Loading...
