Kamstrup flowIQ - Module Slots and Supported Modules

10 Kamstrup A/S • 55122714_A2_GB_04_2021
flowIQ® Gateway
3.7.1.1 Supported flowIQ® meters
flowIQ® meters Proprietary Kamstrup communication
flowIQ® 2200 with wM-Bus/linkIQ® module 61/62
flowIQ® 3200 with wM-Bus/linkIQ® module 63/64
3.7.1.2 Supported data from flowIQ® 2200/3200 meters
Temperature and Advanced Leak Detection data is not forwarded from flowIQ® Gateway.
If you wish to receive this data, import the flowIQ® meter in READy Manager
The following data is synced between flowIQ® Gateway and flowIQ® 2200/3200 meters:
• Volume 1
• Flow (V1)
• Info codes (see the following section)
Please refer to the specific communication module's data sheet on products.kamstrup.com for
further information about data content.
3.7.1.3 Supported info codes from flowIQ® 2200/3200 meters
The connected flowIQ® 2200/3200 meters can forward the following alarms/info codes to
flowIQ® Gateway. The gateway maps the info codes to its own interpretation of the alarms/info codes:
flowIQ® Gateway flowIQ® 2200/3200
The connected meter is Dry V1 Air Dry
The connected meter has Reverse flow V1 Reverse Reverse
The connected meter has registered a Leak Leak out Leak
The connected meter has registered a Burst Burst out Burst
The connected meter has registered Flow above Q
4
V1 is above Q
s
Flow above Q
4
See section 8.2 "Alarms and info codes" for a complete overview of alarms and info codes.
3.7.2 Module slot 1 and 2
Module slots 1 and 2 are for plugging in modules offering different communication types and
protocols.
12