11Kamstrup A/S • 55122714_A2_GB_04_2021
flowIQ® Gateway
3.7.2.1 Supported communication modules
Kamstrup offers support for the flowIQ® Gateway modules listed below only.
Modules are factory-mounted if ordered with flowIQ® Gateway.
Only one installed radio module is supported at the time.
The following communication modules are supported by flowIQ® Gateway.
For examples of combinations and usage, see section 10 "Communication module combinations
and examples".
Article number Module Recommended
datagram
HC-003-10 Data Pulse, inputs (In-A, In-B)
HC-003-11 Data Pulse, outputs (Out-C, Out-D)
HC-003-20 Wired M-Bus, inputs (In-A, In-B)
HC-003-21 Wired M-Bus, outputs (Out-C, Out-D)
HC-003-32 linkIQ/wM-Bus, inputs (In-A, In-B), EU
&
HC-003-33 linkIQ/wM-Bus, outputs (Out-C, Out-D), EU
&
HC-003-41 Analog inputs 2 x 4…20 mA / 0…10 V 41-00-100
"
HC-003-60 LON TP/FT-10, inputs (In-A, In-B) 60-00-100
$
HC-003-66 BACnet MS/TP, inputs (In-A, In-B) 66-00-100
"
HC-003-67 Modbus RTU, inputs (In-A, In-B)
"
HC-003-80 2G/4G Network, inputs (In-A, In-B) 80-10-101
&$
HC-003-82 Modbus/KMP TCP/IP, inputs (In-A, In-B)
$
HC-003-83 READy Ethernet, inputs (In-A, In-B) 83-10-100
$
"
The module requires that the meter is mains-supplied
$
The module requires that the meter is mains-supplied with a High Power supply
&
The module requires an antenna
To Next Page
Loading...
