EasyManua.ls Logo

Kamstrup MULTICAL 403 - 9 Communication Modules; Module Overview; Pulse Inputs; Pulse Outputs

Kamstrup MULTICAL 403
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 Kmsrup A/S • 55121739_A4_GB_11.2017
MULTICAL® 403
9 Communication modules
MULTICAL® 403 cn be exended by  wide rnge of exr funcions by mens of communicion
modules. Below, pulse inpus/oupus nd module ypes re briefly described.
Note: Before replcing or mouning modules, he supply o he meer mus be swiched off. The
sme pplies for mouning of n nenn.
9.1 Module overview
MULTICAL® 403 communicion modules
Type No. Description
HC-003-10 D + 2 pulse inpus (In-A, In-B)
HC-003-11 D + 2 pulse oupus (Ou-C, Ou-D)
HC-003-20 M-Bus + 2 pulse inpus (In-A, In-B)
HC-003-21 M-Bus + 2 pulse oupus (Ou-C, Ou-D)
HC-003-30 Wireless M-Bus, configurble, 868 MHz + 2 pulse inpus (In-A, In-B), inernl or
exernl nenn.
9.2 Pulse inputs
Pulse inpus A nd B re used for connecion of
exr meers wih eiher Reed-swich oupu or
pssive elecronic pulse oupu.
Minimum pulse durion is 30 ms, mx. pulse
frequency is 3 Hz.
If  module wih pulse inpus is mouned in
MULTICAL® 403, he meer is uomiclly configured for pulse inpus. Plese noe h he pulse
figure (lires/pulse) mus mch he exr wer meers nd he configurions of inpus A nd
B. Afer delivery he configurions of pulse inpus A nd B (config FF nd GG) cn be chnged by
mens of he PC progrm METERTOOL HCW.
9.3 Pulse outputs
Pulse oupus for energy nd volume re
mde wih drlingon opocouplers, he pulse
oupus re vilble on  number of he
communicion modules.
Mx. volge nd curren of he oupus re
30 VDC nd 10 mA respecively.
When  module wih pulse oupus is mouned in MULTICAL® 403, he meer is uomiclly
configured for pulse oupus. The pulse durion is ordered  32 ms. or 100 ms. Afer delivery he
pulse durion cn be chnged by mens of he PC progrm METERTOOL HCW.
The resoluions of he pulse oupus lwys follow he les significn digi displyed for energy
nd volume respecively.
65 +
Pulse inpu A
66 -
67 +
Pulse inpu B
68 -
16 +
Pulse oupu C
17 -
18 +
Pulse oupu D
19 -

Other manuals for Kamstrup MULTICAL 403

Related product manuals