Need help?Do you have a question about the Kamstrup ULTRAFLOW 54 Series and is the answer not in the manual?
General| Brand | Kamstrup |
|---|---|
| Model | ULTRAFLOW 54 Series |
| Category | Measuring Instruments |
| Language | English |
Details electrical specifications like supply voltage, mains supply, and power consumption.
Lists flow rates, dynamic range, pressure loss, and minimum cutoff values.
Lists type numbers, flow rates, connections, and material for ordering.
Explains electronic devices for adapting signals and extending cable lengths.
Details mounting orientations and important considerations for flow sensor installation.
Specifies recommended installation methods to avoid flow disturbances.
Defines minimum back pressure requirements to prevent cavitation and errors.
Details wiring diagrams for connecting ULTRAFLOW® and related accessories.
Shows practical examples of electrical connections for various configurations.
Explains the basic principles of ultrasonic flow measurement.
Describes how flow velocity and volume are calculated using transit time.
Provides recommendations for system pressure and flow to ensure accuracy.
Covers galvanic separated output modules (Y=2 and Y=3) for pulse transmitters.
States the permitted tolerances according to EN 1434 for different flow ranges.
Outlines the routine for calibrating using serial data and external control.
Details the three-wire cable connection and output module specifications.
Provides recommended flow rates, durations, and quantities for testing.
Introduces the Pulse Tester tool and its functions for calibration.
Explains how to read and write flow meter corrections and flow curves.
Guides on setting up and programming Pulse Divider type 6699-607.
Introduces METERTOOL HCW software for configuring heat, cooling, and water meters.
Details general information and programming for Pulse Divider 66-99-907.
To Next Page