EasyManuals Logo

Kamstrup ULTRAFLOW 54 Series User Manual

Kamstrup ULTRAFLOW 54 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
ULTRAFLOW®54(H)/(J)
KamstrupA/S∙TechnicalDescription∙5512‐1554_J1_GB_04.2018
79
11.2 Pulse Divider 66-99-907
11.2.1 General information
It is important to be familiar with the Pulse Divider’s functions before starting programming.
Kamstrup's software product “METERTOOL HCW” (66-99-724) is used for Pulse Divider 66-99-907. For Pulse Divider
66-99-607 see paragraph 10.4.4.
Before running the program, the interface cable with USB and 4-pole connector must be connected to a USB-port
in the PC and the 4-pole connector in the Pulse Divider.
Note: The supply to the Pulse Divider must be disconnected during programming. The Pulse Divider is powered
through the connected interface cable.
Start METERTOOL HCW and click on „Connect“ in METERTOOL HCW. It is not important whether the program is in
basic or advanced mode.
Figure 67. Connect to meter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kamstrup ULTRAFLOW 54 Series and is the answer not in the manual?

Kamstrup ULTRAFLOW 54 Series Specifications

General IconGeneral
BrandKamstrup
ModelULTRAFLOW 54 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals