ULTRAFLOW®54(H)/(J)
78
KamstrupA/S∙TechnicalDescription∙5512‐1554_J1_GB_04.2018
11 METERTOOL for HCW
11.1 Introduction
Kamstrup's software product “METERTOOL HCW” (66-99-724) is used for configuration of Kamstrup heat, cooling
and water meters.
The following instructions are based on version 1.0.7.0.
11.1.1 System requirement
METERTOOL requires minimum Windows XP SP3, Windows 7, Home Premium SP1 or newer as well as Windows
Internet Explorer 5.01 or newer.
Minimum: 1 GB RAM Recommended: 4 GB RAM
10 GB HD 20 GB HD
Display resolution 1366 x 768 1920 x 1080
USB
Printer installed
Administrator rights to the PC are required in order to install and use the programs. The programs must be installed
under the log-on of the person who is to use the programs.
11.1.2 Interface
See paragraph 10.2.1
11.1.3 Installation
Check that system requirements are fulfilled.
Close other open programs before starting the installation.
Download the METERTOOL-software from Kamstrup's FTP-server and follow the program’s directions.
During the installation of the METERTOOL program the USB-driver is automatically installed if it has not been
installed already.
When the installation has been completed, the icon “METERTOOL HCW” will appear in the menu "All Programs"
under ‘KAMSTRUP METERTOOL’ (or from the menu "Start" for Windows XP) and as a link on the desktop. Double-
click on link or icon in order to start the program.
To Next Page
Loading...
Need help?
General
