What to do if Kamstrup MULTICAL 801 Measuring Instruments shows no energy accumulation?
If your Kamstrup Measuring Instruments show no energy or volume accumulation, start by checking the error code as described in paragraph 6.8. If the info code is 000, ensure the flow direction aligns with the arrow on the flow sensor. For info codes 004, 008, or 012, inspect the temperature sensors; replace them if they are defective.
Why is my Kamstrup Measuring Instruments temperature reading incorrect?
If your Kamstrup Measuring Instruments display an incorrect temperature reading, the issue might stem from a defective temperature sensor or insufficient installation. Consider replacing the sensor pair and verifying the installation.
Why Kamstrup MULTICAL 801 accumulate volume but not energy?
If your Kamstrup Measuring Instruments are accumulating volume but not energy, it's possible the inlet and outlet sensors were interchanged during installation or connection. Ensure the sensors are mounted correctly to resolve this.
How to fix a Kamstrup MULTICAL 801 Measuring Instruments with an empty display?
If your Kamstrup Measuring Instruments display is not functioning, it is likely due to a missing power supply. Try changing the backup battery or checking the mains supply.
What to do if Kamstrup MULTICAL 801 are not accumulating volume?
If your Kamstrup Measuring Instruments are not accumulating volume, the issue might be due to a lack of volume pulses. Verify that the flow direction matches the arrow on the flow sensor and check the flow sensor’s connection.
Why is the temperature reading low on Kamstrup MULTICAL 801 Measuring Instruments?
If your Kamstrup Measuring Instruments show a slightly low temperature or energy accumulation, it could be due to poor thermal contact, heat dissipation, or short sensor pockets. Ensure the sensors are at the bottom of the sensor pockets, insulate the pockets, or replace them with longer ones.
How to correct an incorrect volume accumulation on Kamstrup MULTICAL 801?
If your Kamstrup Measuring Instruments are accumulating volume incorrectly, the cause might be erroneous programming. Check that the pulse figure on the flow sensor matches the calculator.
Details the mounting procedure for direct temperature sensors.
Explains the installation process for temperature sensor pockets.
Guides on installing couplings and direct sensors in ULTRAFLOW® parts.
Instructions for mounting ULTRAFLOW® for pipe sizes up to DN125.
Provides installation guidance for ULTRAFLOW® 54 for DN150 and larger.
Illustrates various electrical connection scenarios for sensors and modules.
Details the GSM/GPRS module for transparent data communication.
General| Brand | Kamstrup |
|---|---|
| Model | MULTICAL 801 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
