Kamstrup MULTICAL 801 - General Information

6 Kamstrup A/S • 5512603_C1_GB_03.2016
MULTICAL® 801
1 General information
Please read this guide before installing the energy meter.
If the meter is installed incorrectly, Kamstrup’s warranty obligations
will no longer apply.
Plese note tht the following instlltion conditions must be obeyed:
- Pressure stge ULTRAFLOW®: PN16/PN25/PN40, see mrking. Mrking
of flow prt does not cover included
ccessories.
- Pressure stge Kmstrup
sensor set type DS: PN16
- Pressure stge Kmstrup
pocket sensors type PL: PN25/PN40 - depending on type
If the medium temperture exceeds 90 °C we recommend using flnge
meters.
Plese mke sure tht MULTICAL® 801 is connected to correct voltge, either
230 VAC or 24 VAC. See the mrking t terminls 27 nd 28 t the bottom
left.
MULTICAL® 801 must be seled with sel nd wire or  seling lbel fter
mounting.